Angle steel production line Use Precautions
The normal use of the angle steel production line should pay attention to these points. The normal operation of the angle steel production line must meet the following conditions. The power supply voltage at the location of the production line has small fluctuations, and the temperature should be less than 30 degrees Celsius, which is 80% of the outside temperature.
(1) Environmental requirements
The angle steel production line should avoid direct sunlight, and it is necessary to keep away from the influence of humid airflow as much as possible. If there is a vibration source near the angle steel production line, as there is a vibration source near the angle steel production line, anti-vibration trenches should be set around the production line. Otherwise, it will directly affect the accuracy of product processing, cause poor contact of various components, and directly reduce the reliability of the production line.
(2) Power requirements
Generally, the angle steel production line is installed in the processing workshop. The environment temperature will vary greatly, the conditions are quite bad, there are many kinds of equipment, and the heat dissipation is serious. Therefore, the angle steel production line must be installed with a relatively stable voltage. The voltage fluctuation must be within the allowable range, so that the entire production system can operate normally
(3) Temperature condition
The ambient temperature of the angle steel production line is lower than 30 degrees Celsius, and the relative temperature of the outside is less than 80%. Generally speaking, an exhaust fan or air cooler is generally installed inside the numerical control electric control box to keep the electronic components, especially the central processing unit, with a constant working temperature or a small temperature difference. Excessive temperature and humidity will reduce the life of control system components and cause more failures. The temperature and humidity will rise, and the increasing dust will cause adhesion on the integrated circuit board and cause a short circuit.
(4) Used according to the instructions
When using the angle steel production line, general users are not allowed to change the parameters set by the manufacturer in the control system at will. The setting of these parameters is directly related to the dynamic characteristics of the various components of the angle steel production line. Only the value of the gap compensation parameter can be adjusted according to the actual situation.
(5) Precautions
The user must not arbitrarily replace the angle steel production line accessories, such as the hydraulic chuck that exceeds the specifications specified in the manual. The general manufacturer will first consider the matching of each link parameter when setting up the accessories. Blind replacement causes mismatch of various link parameters, and even causes unexpected accidents. The pressure of the hydraulic chuck and the hydraulic tailstock should be within the allowable stress range, and any change is not allowed.