6 methods for daily maintenance of lockformer pittsburgh machine
1. The four side handles should be used for manual transportation or lifting of the lockformer pittsburgh machine. Do not force the table panel, or even lift the machine by lifting the panel.
2. Add calcium-based grease to the tooth surface of the transmission from time to time to reduce the wear of the tooth surface.
3. Keep the surface of the rolling wheel clean, clean up the adhesion in time, lockformer pittsburgh machine common plate flange machine, air pipe plasma cutting machine, and apply anti-rust grease on the surface of the rolling wheel when the air pipe production line is out of service for a long time.
4. Frequently check the working condition of the system. Pay special attention to the needle bearings. If there is any damage, it should be replaced and repaired immediately.
5. If it is found that the speed of the rolling wheel is slow or the operation is weak, it may be caused by the looseness of the V-belt. You can move the position of the motor and re-tension the V-belt to recover
6. Every six months is a maintenance cycle, the upper and lower rack wall plates and needle roller bearings should be removed, and ZL45-2 rhenium-based grease should be reapplied.