6 methods for daily maintenance of pittsburgh lockformer machine
1. The four side handles should be used for manual handling or lifting of the machine. Do not force the table panel, or even lift the machine by lifting the panel.
2. Add calcium-based grease to the tooth surface of the transmission from time to time to reduce the wear of the tooth surface.
3. Keep the surface of the rolling wheel clean, clean up the adhesion in time, pittsburgh lockformer machine common plate flange machine, air pipe plasma cutting machine, and apply anti-rust grease on the surface of the rolling wheel when the air pipe production line is out of service for a long time.
4. Frequently check the working condition of the system. Pay special attention to the needle bearings. If there is any damage, it should be replaced and repaired immediately.
5. If the rotation speed of the rolling wheel is slow or the operation is weak, it may be caused by the slack of the V-belt. You can move the position of the motor and re-tension the V-belt to recover return to normal.
6. Every six months is a maintenance cycle, the upper and lower frame wall plates and needle roller bearings should be removed, and ZL45-2 rhenium-based grease should be reapplied.